FubarIO-MK2 is a plug and play high quality USB device used for recording and playback and works without installing any drivers with Windows, Unix and Mac OS. It does playback and recording, so you get a DAC (Digital to Analog Converter) and a ADC (Analog to Digital Converter). The new FubarIO-MK2 has an adjustable input level for adjusting the input level to most input sources, needed for advanced recording.

Specifications:

Amplifier Structure : Low pass filter with 2Vrms output

Power Structure : Virtual-Ground power supply

Sample Rate (Supported)

Playback : 16-bit, 8kHz / 16kHz / 32kHz / 44.1kHz / 48kHz / 96kHz

Recording : 16-bit, 8kHz / 16kHz / 32kHz / 44.1kHz / 48kHz / 96kHz

Circuit Protect : Output short / Over current protect

USB Codec : Tenor - TE7022

A/D Converter : Cirrus - CS5343

D/A Converter : Wolfson - WM8761

OPAmp : TI - NE5532

Audio Performance Playback :

2Vrms output, 16-bit / 48kHz

Frequency response (From 40Hz to 15kHz) : +0.02dB to -0.04dB

Noise level (1kHz, A-Weighted) : -94.6dB

Dynamic range (1kHz, A-Weighted) : 95.9dB

THD% : 0.0022%

Stereo crosstalk : -95.9dB

Audio Performance for Recording:

2Vrms output, 16-bit / 48kHz

Frequency response (From 40Hz to 15kHz) : +0.01dB to -0.09dB

Noise level (1kHz, A-Weighted) : -98.8dB

Dynamic range (1kHz, A-Weighted) : 98.7dB

THD% : 0.0034%

Stereo crosstalk : -89.2dB

Connectivity:

USB interface (USB 1.1)

Line Output : 1 of RCA jack - Playback, (Users can change the function to monitor the recording by the switch on faceplate)

Line Input : 1 of RCA jack - Recording, (Users can adjust the entered level by the knob on faceplate)

System Requirements:

Intel® Pentium® 2, Celeron® 800MHz or higher computer system

Microsoft® Windows 2000® (Service Pack 4) or Windows® XP (Service Pack 1)

128MB RAM

Available USB port

Scope of supply:

Fubar IO MKII

DC24V 0.5A power adapter

RCA wire

USB wire

User manual

Warranty card

Wrench