Rega EAR Headphone Amp

(0) No Reviews yet
SKU: RE-EAR Rega EAR Headphone Amp
Headphone lovers rejoice! The Rega EAR Headphone Amp has been redesigned from the ground up for better performance, noise reduction, and a matching aesthetic to the new Apollo-R, Brio-R, and DAC. The EAR benefits from a comploetely new surface mount PCB layout based on the hugely successful and award-winning Brio-R integrated amplifier. This includes the design ideals of the cascaded emitter-follower output stage and a pair of complimentary Darlington output transistors, along with polyester film and Nichicon FG capacitors in critical positions. It pushes the Brio-R amplifier circuit concept to a whole new level, however, with the use of a low noise fully regulated power supply and an external mains transformer. This reduction in noise along with a low output impedance makes it suitable for us as a studio or Hi-Fi headphone amplifier. The new EAR is housed in a compact case designed to match the current range of electronics (Apollo-R, Brio-R, and DAC) with a high-gloss front fascia. It is available in Black only.
  • Open circuit voltage: 6V ‡
  • Input impedance: 20K
  • ‡ Gain: 28dB ‡
  • Frequency response: 12Hz to 37kHz ‡
  • THD: typically .003% ‡‡
  • Signal to noise ratio referenced to max output level: 100dB (22Hz - 22kHz) ‡
  • Dimensions: 7”W x 6”D x 1.77”H
  • Maximum power requirements: 24VAC at 225mA (685mW at 32Ohms)
  • ‡ Maximum Ouput Level , adjusted for impedance: ‡
  • 25Ohm load 775mW
  • 32Ohm load 685mW ‡
  • 50Ohm load 530mW
  • ‡100Ohm load 320mW
  • 600Ohm load 60mW
  • Ratings & Reviews

    No reviews available

    Be the first to Write a Review