• Home
  • Rothwell Audio XLR In-Line Attenuator

Rothwell Audio XLR In-Line Attenuator

(0) No Reviews yet

Out of stock


XLR In-Line Attenuator

These audiophile devices simply plug into any input sockets and reduce signal levels by 10dB. They can be used with integrated amps or pre/power amps, and are compatible with equipment over the entire price spectrum, from budget to extreme high end.

When used with integrated amps (simply plug them into any input sockets, then plug the source component into the attenuators) the volume control will be two or three "hours" further round its range than it was before, giving better control at low levels and operating well away from the end stops. When used with pre/power amps, there is an added benefit.

A high quality device to reduce signal levels by 10dB to give a better range on the volume control, to increase headroom, or to improve signal to noise ratio. These are our most famous product with thousands sold all over the world.
  • turns ratio 1:12.9
  • voltage gain 22dB (x12.9)
  • input impedance* 100 ohms
  • optimum load impedance** 47k + 150pF
  • bandwidth 5Hz - 36kHz (+0/-3dB)
  • cartridge compatibility (o/p) 0.3mV - 0.7mV
  • cartridge compatibility (imp.) internal impedance <20 ohms
  • dimensions 60 x 155 x 92 mm
  • weight 580g
  • Ratings & Reviews

    No reviews available

    Be the first to Write a Review